rev:May 27, 1997
Return Home page
BACK(Master GOLD PAGE)
How to choose a Gold Conjugate (by BBI international)
The aim of an antibody incubation with a specimen, whether it be a section,cells in suspension, a tissue slice, a blotted membrane or a rapid diagnostic test assay, is to achieve the most intense specific signal and the least non specific background possible.
Direct or Indirect labelling (antibodies)
Gold conjugates may be used directly or indirectly to label antigens as indicated above. In the direct method the gold is conjugated to the primary antibody, whether monoclonal or polyclonal. This allows a single incubation to be performed and provides the simplest detection system. In the indirect method a primary unlabelled antibody is applied to the specimen to locate the antigen. This is followed by a gold labelled secondary that detects the primary antibody. This gold labelled secondary antibody is almost always an affinity purified polyclonal. In this way an amplification of the signal is achieved, often up to 10x compared with a direct incubation, according to the particle size. The choice of the most appropriate system depends upon the type of component to be detected and what binding proteins are available. Some guidelines on making this choice are given below.
An extension of the indirect method may be used where there is no appropriate gold labelled secondary to match the primary antibody For example if the unlabelled primary is from Pig and there is no matching gold labelled anti-Pig (say Rabbit anti-Pig) may be used as a second step followed by a gold labelled third antibody (say Goat anti-Rabbit) that will detect the second antibody. The indirect method is the most common for studying cells and tissues and avoids the need to label every primary antibody. It provides a universal method for detecting any primary antibody from the same primary species, ie all Rabbit antibodies may be detected by Goat anti-Rabbit gold conjugates, etc. The indirect method because of the need for two (or three) separate incubations but is the more widely used. The previous table indicates secondary gold labelled antibodies to be used with any chosen primary.
Absorption with serum proteins
Antibody-gold conjugates are absorbed against certain species of serum proteins as shown in the table above and as detailed in each Section. This absorption reduces cross reactions to those species to an absolute minimum.
When to use F(ab') fragments?
In some applications background labelling may be a problem due to the attraction
of the Fc region of the antibody-gold conjugate to tissue components (called
Fc receptors). Normally this is blocked by the simple application of normal
serum prior to the first antibody . If the problem persists, however, then
gold labelled F(ab') fragments of antibodies may be used. These conjugates
are listed in each Section
When to use antibodies, Protein A, Protein G or Protein A/G?
Protein A (PAG), Protein G (PGG) and Protein A/G(AG) are all separate proteins and will mimic a secondary antibody by binding to the Fc part of primary antibody. In some situations they may be used in place of the secondary antibody. Unlike secondary antibodies, however, it is believed that there is only a single binding site for these proteins on the primary IgG. They do not bind with great affinity to IgM or IgA molecules.The advantage of these proteins is that they provide a universal second step for a wide range of primary antibody species. They each bind with varying affinities to IgG molecules of different species as shown in the table (below). However, if possible we would always recommend the selection of a species specific secondary antibody in preference to Protein A,G or A/G.
|Guinea Pig IgG||++||++||++|
Streptavidin or Goat anti-Biotin?
For the indirect detection of a biotinylated primary antibody or nucleic
acid probe there is a choice of Streptavidin: gold or Goat anti-Biotin: gold
conjugates. Historically streptavidin has been the most frequently used detector
for biotin because of the very high affinity constant between them. Most
recently, however, Goat anti-Biotin has been shown to be a rather more sensitive
detector of biotin compared to streptavidin when conjugates to gold particles.
This is because of the relatively large molecular size of the anti-biotin
molecule (160,000 daltons) compared to streptavidin (40,000 daltons) and
the distance between the binding site of the gold on the Fc from the binding
region of the antibodyF(ab'). This is especially so when using larger gold
particles but becomes insignificant for 5nm and 1nm gold conjugates. On occasions
where background from non-specific attraction of goat antibodies may
cause a problem streptavidin may provide a cleaner result. We recommend beginning
with Goat anti-Biotin gold conjugates for the detection of biotin.
Cationic gold allows highly sensitive and discrete microscopical studies of anionic (ie negative) sites in cells and tissues(1). The gold conjugate is made by careful conjugation to poly-L-Lysine, a highly positive amino acid chain. A simple one step incubation of sections with the diluted Cationic Gold conjugate reveals subcellular sites having net negative charge. The charge distribution can be seen at a range of magnifications by using Cationic Gold of different particle sizes.
Most cells of eukaryotic origin have a net negative surface charge from anionic
plasma membrane components. This charge distribution is thought to be important
in movement of various soluble macromolecules across cell walls. Thus the
role of the surface charge in cellular behavior through interaction with
neighboring cells can be studied. For in vitro and in vivo studies Cationic
Gold may also be used effectively to study the uptake of anionic material
1. Bush MS and Allt G(1990) "Blood nerve barrier: distribution of anionic sites on the endothelial plasma membrane and basal lamina." Brain Res 535, 181-188.
How to Choose the Gold Particle Size
A wide range of particle sizes can be conjugated to proteins and macromolecules. In principle smaller gold particles produce a higher labelling intensity on the specimen. This is because of the reduced stearic hindrance to antigen detection. Typically an antibody of 160,000 daltons molecular weight will have a linear dimension of 8nm. Thus a 1nm gold particle,attached to the Fc region will hardly impede the antibody activity. A 20nm particle, however, while being more visible, will produce a greater stearic hindrance by its proximity to the antigen binding region of the antibody. In addition the increased charge repulsion between larger particles reduces the number of labelled antibodies gaining access to the target antigen.
Different particle sizes are appropriate for different types of application as described below.
a) Light Microscopy
Gold particles cannot easily be seen in the light microscope by bright field viewing. They must thus be silver enhanced for greatest visibility. Small gold particles will give the greatest number of gold labelling on the specimen and each particle can then be subsequently silver enhanced for maximum visibility of signal. A choice can be made between 1nm and 5nm gold conjugates.
The 5nm conjugates are used for most standard purposes and are recommended
for initial studies. For even greater labelling intensity the 1nm gold conjugates
are preferred. In both cases the gold signal is silver enhanced to make it
visible in the light microscope. The 1nm gold conjugates are particularly
useful when penetration into cells and tissues (eg preembedding labelling)
is required. Silver enhancing . see
LM secton for a list
of available conjugates.
b) Transmission Electron Microscopy (see EM section for available gold conjugates)
For electron microscopy any particle size may be employed. For low magnification
work larger particles (eg 15-30nm) are more easily seen. For high magnification
studies the smaller particles (eg 5-10nm) are preferred. Again, smaller particles
give higher labelling intensity and may be subsequently silver enhanced on
the section to produce larger particles with this high labelling intensity.
For ultra high sensitivity the 1nm gold particles can also be chosen but
are usually visualized only after silver enhancing on the section .
For those just beginning immunogold labelling in the EM or performing studies over a range of magnifications, 10nm gold conjugates are recommended.
c) Scanning Electron Microscopy
The resolution of the scanning electron microscope indicates that larger gold particles (eg >20nm) should be used for detection by back scattering electron signals. However, as mentioned above, a greater intensity of labelling is achieved with smaller gold particles which can be subsequently silver enhanced with the LM/EM Silver Enhancing Kit (code SEKL15). We would therefore recommend that a choice is made for SEM studies between 20 or 30nm gold conjugates for direct (unenhanced) viewing, or 5nm conjugates which can be simply silver enhanced within minutes for observation at low magnifications. With the latter approach each gold particle grows spherically to approximately 3-nm in 3-5 minutes. The reaction is simply stopped by washing in water.
d) Blotting (see BL section for available conjugates)
For blotting applications where the gold conjugates are to be applied to
proteins immobilized on nitrocellulose membranes, the choice is between 1nm
and 20nm BL Grade gold conjugates. Even 5nm conjugates may also be used very
effectively (LM Grade) together with subsequent silver enhancing. For ultra
high sensitivity 1nm conjugates are preferred in combination with silver
enhancing. However the 20nm gold conjugates allow blotted proteins to be
identified on the immobilizing membrane without silver enhancing. The 1nm
and 5nm (LM Grade) gold conjugates,because of their much reduced stearic
hindrance and greater particle density in solution, may be diluted much further
to provide the same final intensity compared with the 20nm conjugates. The
1nm and 5nm (LM) gold particles must be enhanced with the BlottingSilver
Enhancing Kit (code SEKB250).
Glycerol or Non Glycaerol?
standard Gold Conjugates are presented in a buffer containing 20% glycerol
to allow good freezing characteristics. In most cases this causes no difficulties
since the gold conjugates may be used highly diluted and specimens are fixed
and embedded. On some occasions, however, when using the gold conjugate at
high concentrations (eg 1:2) the presence of high glycerol content may interfere
with satisfactory labelling of cells. Such specimens may include fixed cells
in suspension or in cell culture where the glycerol may cause shrinkage of
the cells. Such high concentrations of glycerol may also cause a lack of
clarity of the gold particles in the EM and may even slow down the rate of
labelling through increased viscosity. For such applications it is recommended
that gold conjugates without glycerol are used (using the same product code
number but identified as Non Glycerol-NG).
-see also new
slide adhesives and
mouting media for immunogold work.
copyright by owner 1997
RDI Division of Fitzgerald Industries Intl
34 Junction Square Drive
Concord MA 01742-3049
phone (978) 371-6446 or (800) 370-2222
fax (978) 371-2266
BACK (Master Gold Page)
INDEX (HOME PAGE)